Heavy-gauge vapor barriers, sealed foundation vents, and a dedicated sump discharge line so your New Holland, PA crawl space stops feeding moisture into the floor joists above it.
New Holland, PA crawl spaces vary a lot in how they were originally built, and a liner that's correct for one home can be undersized for another depending on foot traffic and storage use. We size thickness to how the space is actually used.
Every crew member is trained specifically on liner installation, seam sealing, and vent encapsulation, not general basement work.
Our technicians carry encapsulation materials on the truck for most standard-size crawl spaces, cutting down on return visits.
Pricing is based on your crawl space's actual square footage and condition, quoted in writing before liner installation begins.
We measure relative humidity before and after installation to confirm the space is actually staying below the threshold where mold and wood rot take hold.
We scope every Crawl Space Encapsulation job in person before quoting it, since two properties with the same symptom rarely need the same fix.
Before any liner goes down, we pump out existing standing water and remove debris left behind by prior drainage failures.
Liner thickness is selected based on foot traffic and how the space will be used going forward, not a flat default.
Sealed vents are paired with mechanical dehumidification so the space doesn't just trap humidity instead of venting it.
A crawl space needs its own sump basin and discharge line separate from any basement system, since the two spaces drain differently.
Exposed ductwork inside an unencapsulated crawl space collects condensation, which we address by insulating and sealing ducts while the space is open.
This helps us bring the right liner thickness and dehumidifier size on the first visit.
We take humidity and moisture readings to establish a baseline before recommending a system.
We explain trade-offs between liner thickness options so you can choose what fits your budget and goals.
We re-test humidity after installation to confirm the space is holding at a healthy level before we consider the job done.
"Our crawl space had standing water and a mold smell we couldn't get rid of no matter what we tried. Full encapsulation with a dehumidifier fixed it in one visit."
— New Holland Homeowner
"Sump discharge from the old system was dumping water right back next to the foundation. They rerouted it and the crawl space finally dried out."
— New Holland Customer
"Access to our crawl space is tight and awkward, but the crew didn't seem bothered by it at all."
— New Holland Homeowner
"Humidity reading before was over 80%. After encapsulation it's holding steady in the 50s."
— New Holland Customer
We can scope either option depending on your budget and how severe the existing moisture problem is.
We'll recommend a thickness based on how the space is actually used, not just a default.
Some jurisdictions have code requirements around vent sealing, which we'll flag during the inspection if relevant.
Often yes, if the crawl space is the source — sealing and dehumidifying typically resolves musty odors within a few days of installation.
Yes — we extract existing water first, then proceed with liner and vent sealing once the space is dry enough to work safely.
Most residential jobs finish in one to two days depending on square footage and how much prep work is needed.
We encapsulate crawl spaces throughout New Holland and the surrounding New Holland, PA service area, including the zip codes listed below.
Zip codes we serve in New Holland, PA: 17557
Call now for a free inspection and a flat-rate quote before anything gets worse.
Call +1-866-476-1348© SGP Waterproofing. All rights reserved.
